Downloaded from https://www.everyspec.com For Cue 1:4 M .4 t .... Input S(1040) For Cae 2: QG2(t) i " (t 1 )# (t)dt 1 (10-47) tl ~t For cas 3: FIGURE 10O1. S r Ill ustreng Smdo + u 'Qt(t + h q, (tt2O works or devices to put the next unit into opemtion. A-(t )#s (t)dtldt• (10-48) Fig. 1016 shows two elements where A is opeatng +and B is in standby redundancy, For Case 4: waiting until A fails, and S is the sensing and switching mechanism. The device operates in = ihe folowing four mutually exclusive ways: Q g(t q3 q i A~10~ 1 1 ( 0 9 1. S is operating properly. It monitors A, t,0 and if A fais. it turns B on, and the device For the entire device operates until B fails (Case 1). 2.
S fails by not going aIe to senme and/or switch, ad when it fail, A is operative and 4tv device fails when A fails (10-50) (Cue 2). 3. S fails and in failing it switches to B. A i still orperating when S fails, but For the special case of the exponential the.device fails when B fails (Case 3). failure law where X. is the failure rate of the 4. A is operating and 8 fails. The signal switching mechanism, an A = AA = AB is the path through S becomes open or short failure rate of the two systeni A and B, and the entire device fails at the time S fails standby redundancy is better than two sys- (Case4). tems in parallel if X > X s . If A - X., the two The notation for Eqs.
10-46 through types of redundancy are equal; and if X X s , 0-49 follows: paralll redundancy is superior. W= ~axepdf forccc a AThe gain for a specified mission can be SCfailr Cdf for a, , A,BS measured in terms of the ratio of the reliabil- ity of the stracture with standby redundancy pro = lty ht fito the reliability of alternate structures. q, = probability that S -fails and the switch stays on A 1042 OPERATING REDUNDANCY q2 - probability that S fails and the switch goes to B In operating redundancy, s-independent q 3 w probability that S fails in such a way identicai units operate simultaneously with a that the signal path is shorted or open common input (Refs. 1 and 14).
A failure q 1 + q 2 + q 3 =1 detector is associated with each unit, and a 10-16