I -- Downloaded from https://www.everyspec.com AMCP 706-197 3 TThe REPLACE command is a combina- 13-3.3.4 The Command Language tion of the DELETE and ADD commands. The System Definition Language gives the The ALTER command is used to change user the ability to describe a problem. The any one of the entries for an individual item, GEM Command Language is used to instruct such as its parameters, name, resultant name, the computer to do a computation and to or level. Only the item specified is affected by modify the original problem. the ALTER; its lower level items remain the The basic elements (vocabulary) of the same. Command Language are: The VARY command is perhaps the most 1.
Evaluation Verbs: important one, because it gives the user the BEGIN ability to make sensitivity analyses. It does END this by allowing the user to vary the values of USE one or more parameters of items in the sys- NAMING tern description and see the effects of this on CALCULATE the value of the overall system answer. Thus, 2. Modification Verbs: one can determine the sensitivity of the sys- DELETE tern Reliability with Repair to the failure rate ADD and/or repair rate of an individual item or REPLACE group of items appearing anywhere in the ALTER system description. The procedure followed VARY.
in GEM is to compute the system answer for The two commands BEGIN and END are the requested variable for every value of the used to initiate and stop, respectively, the parameter specified in the VARY. Ref. 4 gives GEM program on the computer for the pur- more specific examples of using GEM for a pose of making a "run" on the machine. A sample system; it includes block diagrams, run can consist of one or more problems. GEM input, and GEM output. Each problem starts with the USE card and 4 ends with the NAMING card. The NAMING 13-4 OTHER PROGRAMS statement is followed by any name the user wishes to give the computed answer to the Other computer programs for calculating problem.
various aspects of reliability are listed in Part , The CALCULATE statement requests the Two, Design for Reliability, par. 4-5. In addi- calculation of a variable and is followed by tion, most computer installations have statisti. the name of the variable. For variables which cal packages for performing routine estima- require the statement of a mission time, this tions, and simulation languages for perform. information is stated after the name of the ing Monte Carlo simulation. Few people can variable. know all about all available programs. Special- The verbs DELETE, ADD, REPLACE, ists can assist in selecting a few from the avail.
ALTER, and VARY are used to modify a able many, then help an engineer become system description, familiar with those few. It is better to be able The command DELETE is used to drop a to use handily a fairly good program than to certain portion of the system description. If have only a remote knowledge of several this command is applied to an 03 level item, excellent programs. for instance, then this item and all its lower level items will be dropped from the system REFERENCES * description. j The command ADD will add to the sys- 1. MARSEP, Mathematica Associates. tern description either something that imme- 2. C. Sontz, S. Seltzer, and P.
Giardano, * diately follows the ADD command or a sys- General Effectiveness Methodology, Oper- * tem (or portion thereof) which has been pre- ational Research Society of America, viously described or appears in the Systems Durham, North Carolina, October 18, Library. 1966. I 13-22