Downloaded from https://www.everyspec.com UAMCP 706-197 CHAPTER 6 CREATING THE SYSTEM RELIABILITY MODEL 6.0 LIST OF SYMBOLS set of rules (which will be referred to as "up- state rules") which define satisfactory opera- k-out-of-r.:F = special kind of system, tion of the system (system up) and unsatisfac- see par. 6-3.2 tory operation (system down), as well as the k-out-of-n:G = special kind of system, various ways in which these can be achieved. see par. 6-3.2 If a system operates in more than one mode, a MTF = Mean Time to Failure separate reliability diagram must be developed MTBF = Mean Time Between for each one (Refs. I and 2).
Failures A considerable amount of engineering s- = denotes statistical defi- nten sanalysis must be performed in order to devel- t nition op a reliability model. The engineer proceeds t = time, time-to-failurefollows. X,Y,Z,A,BS,... = events or elements on a I dependency diagram (1) Develop a functional block diagram 'I' e = subsets of 4; ' is a of the system based on his knowledge of the = events reat physical principles governing system opera- ,4,t) =oevents related to ; behavior. is any event = not *P complement of (2) Develop the logical and topological ; t is any event or relationships between functional elements of set the system.
AND, OR = logical operators (AND (3) Use the results of performance evalu- lon; OR - U) ation studies to determine the extent that the A,OO 0 = symbolic elements for systein can onrrate in a degraded state. This a dependency diagram; information might be provided by outside see par. 6-2.3.1 sources. (4) Define the spares and repair strate- gies (for maintained systems). The spares 6-1 INTRODUCTION strategy defines the spares allocated to the system and, in the case of multiple failures, In order to compute the reliability meas- defines the order in which spares are to be ures of a system, it is necessary to develop a used.
The repair strategies define the number reliability model of the system. A reliability of repairmen and the order in which they are model consists of some combination of a reli- to be used in the case of multiple failures. ability block diagram or Cause-Consequence This chapter presents a description of the chart, a definition of all equipment failure engineering analysis procedures, mathematical and repair distributions, a definition of the block-diagramming techniques, and other pro- up-state rules, and a statement of spares and cedures used to construct reliability models. repair strategies.
This chapter is written from "1 the point of view of reliability diagrams, be- 6-2 ENGINEERING ANALYSIS cause historically the material has been pre- sented that way. 62.1 INTRODUCTION 4 A reliability block diagram is obtained from a careful analysis of the manner in Before the reliability model can be con- which the system operates, i.e., the effects on structed, the system must be analyzed.
A overall system performance of failures of the functional block diagram and a dependency various parts that make up the system; the diagram, which define the logical and topolog- support environment and constraints, includ- ical relationships between functioi.al elements ing such factors as the number and assignment and their inputs and outputs, must be devel- of spare parts and repairmen; and the mission. oped. These diagrams can be developed for Careful consideration of these factors yields a electrical, electromechanical, and mechanical 6-1