Downloaded from https://www.everyspec.com AMCP 706-260 TABLE 2-1. CASE TRAVEL OF CAL.45 (11.42 mn) GUN msec msec lb-sec/In. 2 lb-sec in./sec in./sec in./sec In. I At. A , A A!,, 0.A 0A 0.... 1.4 .4 0.70 0.00i'/ 0.2 0.1 0.56 0.089 11.4 12.8 7.10 0.00071 0.3 0.1 1.73 0.275 35.4 48.2 30.50 0.00305 0.4 0.1 1.60 0.25S 32.8 81.0 64.60 0.00646 0.5 0.1 0.88 0.140 18.0 99.0 90.00 0.00900 0.6 0.1 0.52 0.083 10.7 109.7 104.35 0.01043 0.7 0.1 0.36 0.057 7.3 117.0 113.35 0.01134 0.76 0.06 0.16 0.025 3.2 120.2 118.60 0.01186 2- 0.76 5.88 0.935 120.2 005292 2-2.3.5 Driving Spring Design T 1.67 L 2.0 when 25 vi 50 fps Driving springs must be compatible with operation (Ref.
4) and with the space available for their assembly, two 7, factors that limit their outside diameter, and assembled 3.33 T 4,0 when 20 Yj 25 fps and solid heights. The driving springs must also be (Ref. 4) designed to meet the time and energy requirement of the firing cycle and still have the characteristics that are 5.0 T 6.0 when v 1 20 fps essential for maintaining low dynamic stresses. The 7. (Re. 4) criteria for dynamic stresses have been established by Springfield Armory 4 . The procedures in the subsequent where T a surge tim analyses follow these criteria.
T c compression time of spring calculations are P - impact velocity, ft/sec The spring design data developed for the firing cycle K - 1.0 lb/in., spring constant The impact velocity of 50 ft/sec should not be F. - 6.94 lb, spring force at assembled height exceeded, neither should the velocity be less than the lower limit of each range, however, the limits of the Fn = 9.62 lb, static spring force at end of recoil ratio -ed -need riot necessarily be restricted to the two 71 L = 2,72 in., bolt travel lower ranges.
For instance, if speeds are less thin 20 t= 0.15 se, time of tiring cycle ft/sec, the limits of-- may be shifted to the upper range tc =015stieofiigcceT which varies between 3.33 and 4.0, or even to thz first (t0557)tc , 0.42 sec. time of recoil range of limits 1.67 to 2.0. For speeds between 20 and .\O195 / (see par. 2--2.3.2) 25 ft/sec, the limits of the ratio may be shifted to the upper range that varies betweer 1.67 and 2.0.
= 120.4 in./sec, spring velocity of free recoil 'The surge tie, In terms of spring characteristics ls s According to the theory of surge waves in springs, the dynamic stress increases only slightly over the static T - 35.5 x 1C(0 N (2-40) stress if the following conditions exist: 2-11