Downloaded from https://www.everyspec.com AMCP 706.260 DRIVING SPRING FIR'NO PIN RECEIVER // BARREL Figuie 2-5. Sch6matic of Advanced Primer Ignition System moving bolt picks up a round from the feed mechanisms Eqs. 2-14 through 2-39 are again used. Slnca only half and pushes It into the chamber. Shortly before the the Impulse is availab!e to drive the bolt in recog, its round is -:ated, the firing mechanism activitates t.he man -- st be reduced by half In order to retain the primer. Th- firing mechanism is so posltlon.,d and timed 120.4 in./sec velocity of free recob. Thus the weight ,f that the case is adequately supported when propellan:
this bolt assembly is specified as 1.5 lb and &as pressures reach caseAwaiang proportion. The case and bolt become fully seated just as the Impulse of the fFjdt 0.4675 x 386.4 propellant [;is force equals the momentum of the return. Vf - I 1.5 = 120.4 in./sec ing boit. This part of the impulse is usually approxi- Mb nately half the total, thus establishing the driving spring characteristics. As soon as forword motion stops, the continuously Er I M . x 382- x 14500 applied propellant gas force drives the bolt rearward in recoil. D'srng recoil, the case is extracted and the driving 28.2 in.4b. spring comprz.;ed until all the recoid energy is ahiso.-bed to stop the recoiling parts.
If !he sear is held in the reluased poa.oa, ,he cycle Is repeated and firing con- Atcording to Eq. 2-36, the approximate bolt travel tinues autonu.,cally. Firing ceaset when the sear moves is the same (2.58 in.) as that for the simple blowback to the latched position. lii in the preceding problem. Again, as in the earlier proolem, the 2.58 in. bolt travel do" not yield totally 2-3.2 SAMPLE CALCULAT!ONS OF ADVANCED comlatlble results and must be modified to meet the PRIMER IqNITiON rate of fire of 400 rounds per minute or the cycle time ofte -0.15 sec.
2-3.2.1 Firing Rats Since the initial dynamic conditions, impulse and To illustrate the effectiveness of advanced primer energy of recoil ae half as much as those of the pre- ty'-e performance, start with the same initial conditions ceding problem, the spring constant must as be half in as for the simple blo.iback peoblem with -he added order to have the same bolt travel. Eq. 2-37 shows the provision that half the 'npulse of the propellant gas is stl;ng cycle time to be used to stop the returning bolt just as the cartidge seats. Thus . ( eMb 1 F0 "0 2 ;3 0.4675 lb-sec - K + ,Cos F, 2-13