Downloaded from https://www.everyspec.com AMCP 700-250 CHAPTER 3 RiCOIL-OPERATED WEAPONS 3-1 GENERAL approxima-te to !hose needed to absorb the recoil energy of tie bolt. Later adjuinen t can be made in the RecoIl-operated veapons art those weapons that rely propel'ties of all the sprinp in the system to achieve on recoil activity to operate the bolt and related parts. appropriate time and velocity criteria. The bolt, locked to the barrel during firing, Is released during recoil after the chamber pressure has become safe. Action is confined to two general types. long recoll The buffer characteristics should be o arranged that and short re, oll.
its useful potential energy, when fully compressed, approximately equals that of the barrel spring, yet still Is Long recoil has the barrel and bolt recoiling as a unit compatible with other design requirements. This for the entire distance (Fig. 3-;), This recoil distance arrangement gives the barrel sufficient momentum at the must be greate: than the length of the complete round beginning of the counterrecoll stroke for a quick return to provide space for loading. At the end of the recoil without inducing excessive impact when stopping the stroke, the bolt is held while the barrei oounterrecolls returning barrel. aloie.
When sufficient spa develops between bolt and breech, the spent case is ejected. Later, as the barrel 3-3 SAMPLE PROBLEM - LONG RECOIL reaches the in.battery position, the bolt is releabed to M1ACHINE GUN reload the gun, 3-3.1 PECIFICATIONS Short recoil has the barrel ind bolt recoiling as a unit for a distance shorter than the length of the complete Gun: 20 nm machine gun round (Fig, 3-2). Te bolt is unlocked shortly before the barrei negotiates its full stroke. As the barrel stops, Firing Rate: corresponding to minimum bolt travel the momentum of the bolt carries it farther rearward opening a space - between it and barrel - large enough Interior ballstics: Pressure vs Time, Fig.
2-7 for extracting the spent case and reloading. The Aba0.51!.in.2boreare& returning bolt, while reloading, may push the barrel into battery or the barrel may counterrecoil independently of the bolt. 3-3.2 DESIGN DAT- 3-2 LONG RECOIL DYNAMICS L , 10 in, recoil distance The dynarrics of the long recoil-operated gun are Wb - 10 lb, weight of bolt unit similar to those of the blowback types xcept that the barrel ard bolt units recoil together.
Time of recoil may Wt a 50 lb, weight of harr cl unit be decreased by delaying energy of recoil absorption until near the end of the recoil atroke, which can be e a 0.5, efficiency of spring rstem done with a heavy buffer spring operating over a short stroke. The barrel spring sbould be stiff enough to hcld Table 3-1 has the numerical integration for a the recoiling parts in battery while the bolt is returning recoiling weight of 60 lb. The column A represents the whereas the bolt driving spring should be capable of area under the piessure.time curve, Fig. 3-1, for each closing the b)lt in minimal time. The stiffer the spring, interval of time. the less time needed for the return.
However, since the converse is not true, sonie compromise must be arranged to achieve an acceptable firing rate. For initial estimates, the driving spring should have properties that are Fg~t 1 0.515 4 lb-sec. 3-1