Epson Network Guide Network connector RJ-45 connector: This connector is used to connect an Ethernet cable to a network. You can use this cable for 10Base-Te, 100Base-TX, and 1000Base-T Ethernet. c Important: You must use the following shielded twisted-pair cable to connect the network interface to a network. ❏ Category-5 or higher for the 10Base-Te or 100Base-TX connection ❏ Category-6 or higher for the 1000Base-T connection About the Software The Software Disc provided with your printer includes the following network software. Note: The software provided varies depending on your printer model.
❏ EpsonNet Config is a configuration utility for administrators that allows you to configure the network interface for various protocols such as TCP/IP, MS Network, IPP, and SNMP. See “EpsonNet Config” on page 34. ❏ EpsonNet Config with Web Browser is a Web-based configuration utility that allows you to configure the network interface for TCP/IP, MS Network, IPP, and SNMP. See “EpsonNet Config with Web Browser” on page 36. ❏ EpsonNet Print is a utility program that provides peer to peer printing to Epson printers on the TCP/IP network. See “EpsonNet Print (For Windows Users)” on page 40.
Introduction 10 Data light Status light Network Status Green (Flashing) Off Receiving packets (10 M link) Off Green Deep sleep mode (1000 M link) Off Off Deep sleep mode (100 M / 10 M link) Power off mode