1.3 Projector Parts - Interface 13 Rev.A Name Note 1 Computer port (Mini D-Sub15-pin, female) - 2 Audio Out port (Stereo mini pin jack) Outputs audio from the current input source (HDMI/ HDBaseT/LAN/USB). 3 RS-232C port (Mini D-Sub 9-pin, male) - 4 Remote port (Stereo mini pin jack) Connects the remote control using a commercially available 3.5 mm stereo mini-jack audio cable and inputs signals from the remote control. When the remote control is connected, the remote receiver on the projector is disabled. 5 SDI Out/In ports (BNC) The SDI Out port outputs the signal input from the SDI In port. 6 USB-A port (USB connector Type A) When supplying power:
Up to 5V/2A 7 Service port (USB connector Type B) - 8 HDMI port (HDMI) This port is compatible with HDCP2.3. (Audio is only supported by PCM) 9 DVI-D port (DVI-D 24-pin single) This port is compatible with HDCP1.4. 10 HDBaseT port (RJ-45) You can use a network cable up to 100 m in length. To ensure proper data transmission, use a Category 5e STP cable or better. However, operation is not guaranteed for all input/output devices and environments. This port is compatible with HDCP2.3. 11 LAN port (RJ-45) Use a 100Base-TX or 10Base-T network cable. To ensure proper data transmission, use a Category 5 shielded cable or better.