3.2 ESC/VP21 Command List 62 When a command is input, the projector executes the command and returns a ":", and then accepts the next command. If the command being processed terminates abnormally, an error message is output and a ":" is returned. The following list shows the frequently used commands. You can check all available commands in the ESC/VP21 Command List . Rev.A Function Command Setting Value/Response Value Power On PWR ON - Off PWR OFF - Acquire power status PWR? 00: Standby condition 01: Projecting 02: Warm-up status 03: Cooling status 04: Network monitoring status/ communication status 05: Error standby status 09: A/V standby Source selection SOURCE xx 10: Computer 30: HDMI 52:
USB 53: LAN 60: SDI 80: HDBaseT A0: DVI-D F0: Cycle through all sources F1: Cycle through DVI-D, Computer, USB and LAN F2: Cycle through HDMI, HDBaseT and SDI Acquire Source SOURCE? 10: Computer 30: HDMI 52: USB 53: LAN 60: SDI 80: HDBaseT A0: DVI-D Shutter On MUTE ON - Off MUTE OFF - Acquire Shutter status MUTE? ON: Close Shutter OFF: Open Shutter