Installation Position and Environment Aspect ratio 16:6 (EB-735Fi) Installation Position When installing the projector, make sure there is a gap between the wall and the projector's air exhaust and intake vents as shown in the following image. When you select the aspect above and move the [Screen Position] downwards, the shade of the touch unit may appear on the projected image. Install the projector so that it is tilted at an angle of no more than +3 degrees or -3 degrees vertically and horizontally in relation to the screen. When using the Touch Unit, install the projector so that there is a gap between the projected image and the edges of the screen as shown in the following image.
Aspect ratio 16:9 or 16:10 Leaving a gap of approximately 100 mm from the ceiling to the top of the wall plate makes it easier to install and remove the projector. 19 100mm 20m 41-50mm 100mm m 13.7-50mm (EB-725Wi) 17.7-50mm (EB-735Fi) 100mm 100mm 20mm 13.7-50mm (EB-725Wi) 17.7-50mm (EB-735Fi) 100mm 100mm 20mm 100mm