EPSON — Placing ruled lines

Epson L-6034VW Operation Guide Various Print Settings Adjusting the Print Position when Using Eye Marks with the Substrate Reverse Feeding Function When performing reverse feed of the substrate after pausing, use eye marks to increase the accuracy of the print alignment. This section explains how to adjust print data with ruled lines. Follow the steps below to make adjustments when there is a sensor at the die cutting position of the post-processing device. U “Adjusting the Print Position Using a Ruler” on page 132 Note: If the following conditions are the same, you can reuse the adjustment values.

❏ The same substrate model number for the same manufacturer ❏ Substrate width ❏ Distance from the right edge of the print data to the right edge of the eye mark Adjusting Using Print Data with Ruled Lines Prepare the following in advance. ❏ Print data for printing ❏ Loupe with scale Arrange the ruled lines and create print data with ruled lines for adjusting the print data you intend to use. Ruled line designs Create ruled lines following using the following information. Placing ruled lines Arrange ruled lines in print data to be adjusted as shown below.

128 Item Detailed Width 1 pixel (0.125 pt) Length 3mm or more Item Detailed Arrangement Arrange 2 mm inside the right edge and left edge of the print data. However, do not overlap any eye marks. Position Print width direction, overlap 1 mm or more