Epson L-6034VW Operation Guide Various Print Settings c Important: ❏ When performing additional printing, prepare an underlying substrate having a leading margin of 22 m or longer. This is the necessary margin for the reverse feeding. a. Substrate feed direction b. Necessary leading margin = Necessary margin for the reverse feeding ❏ If the margin is less than 22 m, performing Adjust Sensor Sensitivity for eye marks will cause an error. Press Yes to feed the necessary margin for the reverse feeding automatically. Then perform Adjust Sensor Sensitivity with the eye mark at the point where printing can be started. c.
Underlying section not printed ❏ When performing additional printing, use substrate without any splices. The eye mark sensor may not recognize splices correctly. H Press Adjust Eye Mark Sensor on the Loaded Substrate tab from the Substrate Settings menu to perform eye mark detection and adjust the sensitivity of the eye mark sensor. Adjust the eye mark sensor to the eye mark at the point where printing starts. U “Eye mark detection and sensor sensitivity settings during additional printing” on page 55 I Press Adjust Print Position on the Loaded Substrate tab, and then set Adjust Print Position Horizontally and Adjust Print Position Vertically to 0.
J Return to the Operation Status screen, move the press switch from Standby to Ready , and then start printing. Print the first copy, and then pause on the unwinder side workbench. 138