Epson L-6034VW Operation Guide Various Print Settings Necessary settings and procedures for surface printing A Set additional printing for surface printing in a preset suitable to the type of substrate loaded, and set it as the default preset. See the following for more information on creating presets. U “Creating and Editing Preset” on page 114 Lead Out is the necessary margin left before the print start position when printing on the surface. Also, Lead In is the margin after the last page when printing on the surface. When the Lead In is set to 16 m or more in the preset settings, you can print to the final page when printing the rear surface.
B Set surface printing in the preset for reverse feeding, and set it as the default preset. See the following for more information on creating presets. U “Creating and Editing Preset” on page 114 C Check that the press switch is set to the Standby position. D Return to the Operation Status screen to perform printing from the print software, and check that the surface print data has been received. E Select the print job from the Job Management menu, and then press Print Settings . F Set the following, and then press OK . G Load the substrate. Load the substrate so that the unwinder side feeds clockwise.
149 Item Value Lead In 16m or more Lead Out 24m Item Value Reverse Feeding Apply Eye Mark for Reverse Feeding Use Distance from Top Edge of Substrate Apply to print data Distance from Right Edge of Print Job Apply to print data Reverse Feeding Position Adjustment 0mm Item Value Copies 1 Perform Eye Mark Verification Printing Select