EPSON — Stripes may appear in the print outs when using film substrate

Epson L-6034VW Operation Guide FAQ Is there any way to suppress the ink odor? A. If the ink is not curing correctly, an odor may remain. If you are still concerned by the odor after a day, laminate the printed material. Concerned about small text and distortion of thin lines A. Verify the rasterizing data after RIP processing, correct the print data or change the substrate. Confirm the data after RIP processing, and check whether or not text is illegible. If text is illegible in the data, correct any thin and thick lines in the print data using an application such as Adobe Illustrator. If the text is legible, change the substrate, and then re-print.

Stripes may appear in the print outs when using film substrate A. If printing is paused for an extended period, the wettability of the point where the substrate is secured by the nip roller changes, and stripes may appear on the substrate. When the press is set to perform reverse feed of the substrate and when pausing for a long time between the current print job and the next print job The solution differs depending on whether you are cutting the substrate or inserting a margin when printing is complete.

When cutting the substrate when printing is complete, the substrate is not reversely fed before starting the next job; therefore printing is not performed at that point on the substrate where the wettability has changed. If you have not inserted a margin between the next print job in the preset for printing, set Stop Position After Print to Unwinder Side Workbench . When inserting a margin between the current job and the next job, set Lead In to 5 m or more to prevent printing on the area where the wettability of the substrate has changed. When performing base printing and additional printing with the press Note the following points, and then perform base printing.

❏ Reduce the size of the job so that the printing time is less than 30 minutes ❏ Prevent auto head maintenance from starting during printing U “Can I stop the press from entering head maintenance mode during printing?” on page 232 Also, set all three items in Auto Head Maintenance from Print Operation Settings to Do Not Apply . ❏ Do not pause during printing 233 Status Cause and Solution When printing on substrate that absorbs ink, such as uncoated paper and Yupo(R) Ink that gets absorbed into the substrate is difficult to cure. Use the additional UV lamp curing unit (except for Yupo(R)).

When printing images using a small amount of ink Since a small amount of ink can be subject to oxygen inhibition, it is difficult to cure. Leave it for one day.