EPSON — Replacing the unwinder side substrate

Epson L-6034VW Operation Guide Preparing to Print and Printing D On the For Reverse Feeding tab, select the preset for reverse feeding, and then set it as the default preset. Select the preset used for printing, and then press Default Preset Settings . A check mark is displayed on the left of the preset name. If there is no suitable preset available, create a new preset. U “Creating and Editing Preset” on page 114 Note: Set Reverse Feeding to Apply to perform reverse feed of the substrate after pausing and so on. Also, when using eye marks to align the print position, set Eye Mark for Reverse Feeding to Use to enable the eye mark sensor.

When not using eye marks, set Eye Mark for Reverse Feeding to Do Not Use . E From the menu on the left, press Substrate Settings and then Change Substrate . c Important: In the following situations, do not press Change Substrate . ❏ When splicing a new substrate of the same type without changing the paper core during a print job When using one roll substrate and the rewinding tension setting changes during printing, an error may occur in the rotation speed of the drum. If Change Substrate is pressed, replace the rewinder side with a new paper core.

❏ When a roll end error occurs during a print job When replacing with the same substrate from the Change Substrate screen, the print position may shift. Also, do not move the paper edge sensor. U “The print position shifts when replacing with the same type of substrate during a print job” on page 230 35