Epson L-6034VW Operation Guide Preparing to Print and Printing Preparing to Wind the Substrate This section explains the procedure for winding the substrate. Removing Wound up Substrate Caution: ❏ When loading or removing roll substrate, be sure to secure appropriate personnel and appropriate transport equipment such as a lifter according to local laws on health and safety. You can install up to 100 kg of roll substrate (however, the maximum diameter is φ600 mm). Transporting, loading, or removing without following the instructions is extremely dangerous and could cause injuries such as trapping a hand or finger or dropping it on your foot.
❏ Be sure to adopt a sensible lifting posture whenever you lift the roll substrate. If you do not use the correct posture, an injury could occur. A Press the Feed Ready switch on the press to release the tension in the substrate. Check that the Feed Ready switch lamp is off. B Open the rewinder roll cover on the press. 63