Network Guide Solving Problems Note: You can change the connection mode using EpsonNet Config or Web Config. If you do not have EpsonNet Config or Web Config, download them from the following Epson website. http://www.epson.eu/Support (Europe) http://support.epson.net/ (outside Europe) Related Information & “Initializing the Network Settings from the Printer's Control Panel” on page 67 & “Disabling Wi-Fi from the Printer's Control Panel” on page 67 & “Advanced Network Settings” on page 65 Cannot Connect After Trying all Solutions ❏ Restart network devices such as an access point or printer (consider other users who may be using the network).
❏ Initialize all of the printer's network settings, and then set up the network again. ❏ Check the latest firmware update release for the printer or access point. If the latest version has been released, update your device. Note: If you changed the network settings for the printer or the access point, the changes are applied after approximately 30 seconds to one minute.
Related Information & “Initializing the Network Settings from the Printer's Control Panel” on page 67 & “Connection Settings Between the Printer and a Smart Device” on page 10 & “Connection Settings Between the Printer and a Computer” on page 24 85 Hub Auto 1000Ba se-T Full Duplex 1000Ba se-T Half Du- plex 100Bas e-TX Full Du- plex 100Bas e-TX Half Du- plex 10Base- TX Full Duplex 10Base- TX Half Duplex Printer Auto ✓ ✓ ✓ – ✓ – ✓ 100Base-TX Full Duplex – – – ✓ – – – 100Base-TX Half Duplex ✓ – – – ✓ – – 10Base-TX Full Duplex – – – – – ✓ – 10Base-TX Half Duplex ✓ – – – – – ✓