Network Guide Appendix Devices Used to Configure Ethernet Connections The following is a list of the devices shown in the figure above. (a) Modem (b) Router (c) Hub (d) Ethernet Cable (e) Network Interface (f) Printer (g) Computer The following explains the functions of the devices. 87 (a) Modem or Optical Network Unit Connects home or ofcfi e networks to an external network (Internet) with a line through a computer or router. The computer or router cannot receive signals themselves without converting the information. There are two types of devices used to convert information depending on the signal. ❏ Modem:
Converts an analog signal sent from an analog line such as a telephone line into a digital signal, or vice versa. ❏ Optical Network Unit: Converts an optical signal into electrical signal, or vice versa and is installed on the user's side of the network. (b) Router The router is the doorway to the network. They act as a relay point between devices and external signals. If the router is able to connect to the Internet, devices connected to the router are also able to connect to the Internet. Since the router is the doorway to the network, each router can be defni ed as an individual unit of the network. This individual unit is known as a "Segment".
(c) Hub Routers cannot connect directly to a large number of devices. You can use a hub and Ethernet cable (d) to connect several devices such as printers and computers to the router. Some products are a combination of a hub and router.