EPSON — Setting Up a WSD Port – Windows

Network Guide Appendix Click Have Disk and then insert the software disc supplied with the printer. Click Browse , and then select the folder on the disc containing the printer driver. Make sure you select the correct folder. The location of the folder may change depending on your operating system. 32 bit version of Windows: WINX86 64 bit version of Windows: WINX64 7. Follow the on-screen instructions. For Windows XP, setup is complete. For Windows Vista and later, check the port configuration. Checking the Port Configuration - Windows After setting up the port, check the port configuration if you are using Windows Vista or later and using the TCP/IP port for printing. 1.

Open the devices and printers screen. ❏ Windows 8.1/Windows 8 Desktop > Settings > Control Panel > Hardware and Sound or Hardware > Devices and Printers . ❏ Windows 7 Click start > Control Panel > Hardware and Sound (or Hardware ) > Devices and Printers . ❏ Windows Vista Click start > Control Panel > Hardware and Sound > Printers . 2. Open the devices and printers screen. ❏ Windows 8.1/Windows 8/Windows 7 Right-click the printer icon, and then click Printer properties . ❏ Windows Vista Right-click the printer icon, and then select Run as administrator > Properties . 3. Click the Ports tab, select Standard TCP/IP Port , and then click Configure Port . 4. Check the port configuration.

❏ For RAW Check that Raw is selected in Protocol , and then click OK . ❏ For LPR Check that LPR is selected in Protocol . Enter "PASSTHRU" in Queue name from LPR Settings . Select LPR Byte Counting Enabled , and then click OK . Setting Up a WSD Port – Windows This section explains how to set up a WSD port for Windows 7/Windows Vista. Note: For Windows 8, the WSD port is set up automatically. The following is necessary to set up a WSD port. ❏ The printer and computer are connected to the network. ❏ The printer driver is installed on the computer. 96