^LS [Name] Shift horizontal position [Format] ^LS l [Function] Sets the amount to adjust the position of the label’s left edge. The rendering positions for all fields are shifted horizontally to the left the amount specified in Parameter l. If a minus symbol is included for the value for Parameter l, the rendering positions are shifted to the right for the size for the specified value. The following figure indicates the positioning of a field without “^LS” set, and a field where the label left edge adjustment l was specified with “^LS” (The black circle indicates the label origin, and the white circle indicates the field origin).
[^LS not set] [After setting the label left edge adjustment l with ^LS] x Origin (x,y) y ABC [Response] None [Note] If using this command, use it before defining the first field in the label format. The ^JUS command is required to save settings to the non-volatile memory of the printer unit. Please refer to the “^JU” command section for details. [Reference] Related commands: None [Usage example] An example of sending data that sets the amount to adjust the position of the label’s left edge and saves settings to the non-volatile memory of the printer unit is shown below. ^XA ^LS1000 1. Sets the amount to adjust the position of the label’s left edge to 1000 [dot]. ^JUS 2.
Saves the setting to non-volatile memory. ^XZ ESC/Label Command Reference Guide Rev. L Page 174 Parameters Description Definition range l Adjustment for label left edge [dot] -9999 ≤ l ≤ 9999 (Varies depending on the model) x-l y ABC