^MM [Name] Set print mode [Format] ^MM m [Function] Sets the printer operation for when printing is completed. The print mode is set based on Parameter m. The print mode determines the printer operations from the printing of one label to the printing of the next label. Supported modes vary depending on the model. [Response] None [Reference] Related commands: None [Note] The ^JUS command is required to save settings to the non-volatile memory of the printer unit. Please refer to the “^JU” command section for details. [Usage example] An example of sending data that sets the print mode and saves settings to the non-volatile memory of the printer unit is shown below. ^XA ^MMC 1.
Sets the print mode to . ^JUS 2. Saves the setting to non-volatile memory. ^XZ ESC/Label Command Reference Guide Rev. L Page 178 Parameters Description Definition range m Print mode m = T/P/R/A/C T: No cutting P: Manual peeling and application R: Rewind A: Automatic peeling and application C: Cutting performed Print mode Operation after label printing Operation by the next label command No cutting Feeds the label to the manual cut position. Backfeeds the next label to the home position, then performs printing. Manual peeling and application Feeds the label to the manual peeling and application position. Backfeeds the next label to the home position, then performs printing.
Rewind Stops paper feeding at the position where printing ends. Prints the next label from the position where printing ended. Automatic peeling and application Feeds the label to the automatic peeling and application position. Backfeeds the next label to the home position, then performs printing. Cutting performed Feeds the label to the autocutter position and cuts the media. Backfeeds the next label to the home position after cutting. Backfeeds the next label to the home position, then performs printing.