^B(Q [Name] Micro QR Code [Format] ^B(Q o ,v ,s [Function] Sets the Micro QR Code symbol to the field. Sets the field orientation based on Parameter o. Sets the symbol version based on Parameter v. Sets the module size for symbol rendering based on Parameter s. [Encoding] Encoding can be determined by specifying a meta character in the field data specified for the symbol data. The following table indicates the meta characters and explains each one. If B is specified for the character mode, 4 numerals are input after B in the character string to encode. ESC/Label Command Reference Guide Rev.
L Page 46 Parameters Description Definition range o Micro QR Code field orientation o = N (Fixed) N: Normal v Micro QR Code version v = 0/1/2/3/4 0: Auto 1: M1 (11 × 11) 2: M2 (13 × 13) 3: M3 (15 × 15) 4: M4 (17 × 17) s Micro QR Code module size [dot] 1 ≤ s ≤ 99 Meta character Function Description D Specifies the encode mode. D: Can specify multiple character modes within the same single field data. (Not supported in the CW series) Q, M, or L Specifies the error correction level. Refer to the table below. A Automatically specifies input mode. Automatically sets the character mode based on the input data. M Manually specifies input mode.
Specifies the character mode based on the meta characters. N, A, B, or K Specifies the character mode. H: Numerals are specified. A: Alphanumerics are specified. B: 8-bit Latin / kana character set (JISX0201) is specified. K: Kanji that can be specified using Shift-JIS are specified.