The continuous paper layout is shown below. Figure 4.3.2-5 Continuous paper layout Table 4.3.2-5 List of continuous paper setting values Setting a gap between labels of less than 3 mm is not recommended. Refer to the limitations described later for details. Epson ESC/Label Application Development Guide CW-C8000 Series Rev. B Page 24 Item Setting range Recommended initial value Command Black mark No mark Width [mm] 21.4 to 112.0 21.4 to 112.0 108.0 ^S(CLS,P Length [mm] 8.0 to 1016.0 11.0 to 1016.0 152.4 ^S(CLS,L Gap between labels [mm] 3.0 to 6.0 0.0 to 6.0 Less than 3.0 is not recommended 3.0 ^S(CLS,C Left&Right gap [mm] 0.0 to 6.0 0.0 to 6.0 2.0 ^S(CLS,G ^S(CLS,R