5 Various Printing Methods This chapter describes a variety of printing methods using settings and commands. 5.1 Selecting an input resolution Due to the fast print speed of the CW-C8000 series, rendering processing of the printer control software or the printer might not be fast enough to match the print speed. In such cases, continuous printing will frequently stop. Although the default input resolution of the CW-C8000 series is 600 dpi, the input resolution can be changed to 300 dpi in order to avoid the above-indicated occurrence. The printer control software is recommended to allow the user to select the rendering resolution from two types: 600 dpi and 300 dpi.
The default is 600 dpi because the image quality may be reduced at 300 dpi in comparison with 600 dpi, so the user must be informed to select 300 dpi if there are issues with continuous printing. Table 5.1-1 Input resolution An example using an input resolution of 600 dpi was shown in Chapter 3. The information provided here is for an input resolution of 300 dpi. Set each resolution to 300 dpi in the print settings. Be sure to configure this setting before any other. The resolutions that must be set are the format resolution, the print resolution, and the printer resolution before replacement. Set images that are registered in the printer to 300 dpi.
Set the position and size for the print command to values suitable for 300 dpi. Figure 5.1-1 Command structure for an input resolution of 300 dpi Epson ESC/Label Application Development Guide CW-C8000 Series Rev. B Page 43 Input resolution [dpi] Selection standard 600 Default 300 Select if continuous printing stops when using 600 dpi. The print quality may be reduced in comparison with 600 dpi.