EPSON — 5.3.3 Cut

5.3.3 Cut  Function Post-printing operation settings  Command code S(CMP,M,c  Parameters c = T Do not cut (stop at cut position) P Do not cut (stop at peel-off position) C Cut For the CW-C8000 series, use Parameter P: Do not cut (stop at peel-off position) to stop at the specified position without cutting being performed. Labels are cut at the following timing only if cutting is set to be performed after printing.  Timing specified for parameter i of the ^PQ command  When printing of the last label is complete Example 1: Printing and cutting one label ^XA ^S(CMP,M,C Set printer to make a cut ^FO100,100^FD 1 of 1^FS Set printer to print a label ^XZ Example 2:

Printing three labels, cutting and pausing after each label ^XA ^S(CMP,M,C Set printer to make a cut ^FO100,100^FD 3 pages^FS ^PQ3,1 Set printer to print three labels, cutting and pausing after each label ^XZ Example 3: Printing three labels, cutting but not pausing after each label ^XA ^S(CMP,M,C Set printer to make a cut ^FO100,100^FD 3 pages^FS ^PQ3,1,,Y Set printer to print three labels, cutting but not pausing after each label ^XZ Epson ESC/Label Application Development Guide CW-C8000 Series Rev. B Page 57