Storage Towing Capacity table. An unbalanced load on the wheels or a heavier load on the rear may cause the trailer to sway, resulting in loss of vehicle control. • Please always ensure that the load is secured in the trailer and does not move. An moving load can cause loss of vehicle control, resulting in serious injury or death. Towing Mode Before towing, please shift to the P gear, go to the Settings page in the control bar at the bottom of the central display, and tap Drive> Electric Hitch. This will extend the hitch. When a trailer is towed, towing mode must always be active. When you connect the trailer's electrical harness, the vehicle will enable towing mode after you confirm.
Towing mode is deactivated when the trailer's electrical harness is disconnected. To manually enable or exit towing mode, go to the Settings page in the control bar at the bottom of the central display and tap Drive> Towing Mode. One of the following indicators is displayed on the instrument panel at this time: Warning • Before towing, be sure to check that the Tow Mode is on. • Under no circumstances should the Tow Mode be exited during the towing process. Doing so may result in serious injury and/or death. • Do not use the ride height adjustment setting on the center display to properly match the height of the towing device to the height of the trailer.
105 Icon Description The vehicle has detected the connec- tion of the trailer lights, but towing mode is not activated. The vehicle may already have an accessory connected. The vehicle has detected an electrical connection fault with the trailer light. Some or all of the trailer lights may be faulty. To ensure your safety, pull over as soon as possible and check the wiring or connection of the trailer light for faults. If the problem has been resolved but the red icon is still on, please try turning off towing mode and then turning it on again.