NIO Pilot Warning • As a driving assist feature, Auto High Beams cannot handle all situations in all traffic, weather and road conditions. • Please use the high and low beams in compliance with applicable traffic safety laws and regulations. Do not turn on Auto High Beams unless it will not cause any violation of applicable laws and regulations. • The driver should always bear the ultimate responsibility for driving safely in compliance with applicable traffic safety laws and regulations. Enable/Disable the Auto High Beam (AHB) 1. Go to the Settings page from the control bar at the bottom of the central display, and tap Light>Headlamp. Select Turn on the Automatic Headlights. 2.
Go to the Settings page from the control bar at the bottom of the central display, and tap Light>Auto High Beam (AHB) to enable or disable this function. 3. Push the light control lever forward to activate the Auto High Beam (AHB) function. 4. Push the light control lever forward or pull it backward again to enter the standby status of the function. Automatic control may not be performed under, but also not be limited to, the following situations: • Turn on the turning signal. • Turn the steering wheel hard. • Pass a sharp turn. • The wiper is set to its maximum speed. • The fog lights are on. Only targets that satisfy the conditions will be responded to by the Auto High Beams (AHB).
The targets below will not trigger a response, which include but are not limited to: • Pedestrians • Cyclists (including but not limited to bicycles, motorcycles, battery vehicles, tricycles, etc.) 306