System Messages - Alphabetical List User action: Enter another command or exit the editor and reenter from the eV+ monitor. *Can't exit while lines attached* (-355) Explanation: You attempted to terminate execution of the editor while lines were present in the attach buffer. The attach buffer must be empty before the editor can be exited. User action: You can use Shift+Copy to deposit the contents of the attach buffer into the current program. You can also use Esc+K to delete lines from the attach buffer (99 Esc+K deletes up to 99 lines from the buffer). *Can't find calibration program file* (-426) Explanation:
While processing a CALIBRATE command or instruction, the eV+ system cannot find the calibration utility program file CAL_UTIL.V2. User action: Restore the missing file from the eV+ distribution disk to the current default directory, or to the directory \CALIB\ on the local "C" or "D" drive. *Can't go on, use EXECUTE or PRIME* (-313) Explanation: An attempt has been made to continue the execution of a program that has completed or stopped because of a HALT instruction. Normally, an error results when a PROCEED, RETRY, or XSTEP command is entered (or the pendant RUN/HOLD button is pressed) after a program has completed all its cycles. User action:
Use the EXECUTE or PRIME command, or the pendant PRIME function, to restart the program from the desired instruction. *Can't interpret line* (-450) Explanation: eV+ cannot interpret the last command or instruction entered. User action: Verify the spelling and usage, and reenter the line. In the case of an error while loading from the disk, edit the affected programs to correct the indicated lines-they have been converted to bad lines. *Can't mix MC & program instructions* (-414) Explanation: A program instruction has been encountered during processing of a command program, or an MC instruction has been encountered in a normal program. User action:
Edit the command program to use the DO command to include the program instruction, or remove the MC instruction from the normal program. *Can't start while program running* (-312) Explanation: An attempt has been made to start execution of a program from the pendant while a program is already executing as task #0. eV+Language Reference Guide, v2.x, 18319-000 Rev A Page 592