System Messages - Alphabetical List the CALL, CALLS, or EXECUTE instruction, make sure the appropriate commas are included to position the arguments that are present. Program completed (3) Explanation: The program has been executed the number of times specified in the last EXECUTE command or instruction. User action: Any monitor command can be entered, except that PROCEED cannot be used to resume program execution. Program HOLD (15) Explanation: The RUN/HOLD button on the pendant has been pressed while a robot program was executing, and it is now suspended. User action: Any monitor command can be entered.
To continue execution of the program, type proceed or retry , or press the PROGRAM START button on the controller. (The RUN/HOLD button can be held down to temporarily resume execution of the program if the front-panel keyswitch is in the MANUAL position.) *Program interlocked* (-308) Explanation: An attempt has been made to access a program that is already in use by some eV+ process. For example, you have attempted to delete or edit a program that is being executed, or execute a program that is being edited. User action: Abort the program or exit the editor as appropriate and retry the operation.
You can use the SEE editor in read-only mode to look at programs that are interlocked from read- write access. Program name? (None) Explanation: A SEE editor command to change to a different program has been entered. User action: Enter the name of the new program to be edited, or press Return to cancel the request. *Program not executable* (-307) Explanation: Because of program errors detected during loading or upon exiting from the editor, this program cannot be executed. User action: Edit the program to remove any errors. *Program not on top of stack* (-421) Explanation:
A DO context specification has referenced an automatic variable or a subroutine argument in a program that is not on the top of the stack for the specified task. eV+Language Reference Guide, v2.x, 18319-000 Rev A Page 639