System Messages - Alphabetical List *Unknown keyword* (-424) Explanation: The keyword in an FSET instruction is unknown in the context in which it was found. (Most often, a keyword used for a serial line was used when referencing a window or vice versa.) User action: Correct the line in the executing program or reenter the command with the correct keyword. *Unknown network node* (-537) Explanation: A reference has been made to a network node address that is not known by the local network. User action: Make sure that the correct node address was specified. make sure that the remote node is active and connected to the network.
If explicit routing tables are used, make sure that they specify this node. *Variable type mismatch* (-465) Explanation: One or more of the variables in the line is of a type inconsistent with the other variables or with the type required by the command or instruction. For example, you may be trying to mix location variables with real-valued variables. If this error occurs upon exiting from the editor, the variable type within the program conflicts with the type of a global variable that is already defined. User action: Verify the syntax for the operation and reenter the line, correcting the mismatch. Delete conflicting global variables, if appropriate.
*Vision option not licensed* (-770) Explanation: The ACE Sight license is not enabled on the dongle. User action: Install an ACE Sight-enabled dongle on the SmartVision EX or PC. *Warning* Monitoring watchpoint (55) Explanation: Program execution has begun while a watchpoint is set. User action: None. This is an informational message. You may want to disable the watchpoint to eliminate its slowing down of program execution. *Warning* Network monitor interface not open (103) Explanation: eV+ cannot open a network port for use by ActiveeV+. This error should never be seen. User action: Verify that the eV+ controller is properly connected to the network. Reboot eV+ and try again.
eV+Language Reference Guide, v2.x, 18319-000 Rev A Page 660