SRV.RESET monitor command SRV.RESET monitor command Syntax SRV.RESET Function Rescans the IEEE 1394 (FireWire) servo network and reapplies the configurations. Details An error message is displayed if any eV+ tasks are active when this command is issued. In response to this command, power is disabled, the FireWire network is rescanned and the configurations are reapplied. The name of each configured robot module is displayed on the monitor window along with any errors that may have occurred while initializing the module. Related Keywords SRV.NET monitor command eV+Operating System Reference Guide, 2.x,18321-000 Rev A Page 158