MIL-HDBK-304C during these operations as exemplified by Figure 4-1, produces severe impacts to the packages that might exceed all other forces received during shipment. Packaging designers have achieved much success in preventing shipping losses due to shock by designing their packages and cushioning systems according to the presumption that shocks received by the packages during handling operations will be the most severe received during the entire shipment. Generally, the intensity of shocks applied during laboratory testing of military packages is controlled by the impact velocities and surfaces required by various performance tests. 4.4.3 Drop Heights and Handling Effects.
Shocks result from many types of events, but it is generally agreed that the most severe shocks a package will receive occur during handling operations. These include the time when a package is dropped while being loaded or unloaded from a vehicle, sorted or staged for further distribution, or when bulk is being made or broken. It is important, therefore, to identify the drop height from which the package will be expected to fall. (16) 4.4.3.1 General Conclusions. The following are some general conclusions about drop heights resulting from handling. (14) 1.) The probability of a package being dropped from a high height is minimal.
2.) Most packages receive many drops at low heights, while relatively few receive more than one drop from higher heights. 3.) Unitized loads are subjected to fewer and lower drops than individual packages. 4.) Most packages are dropped on their bases. In most studies, base drops have averaged over 50% of the total number of drops. 5.) The heavier the package, the lower the drop height. 6.) The larger the package, the lower the drop height. 7.) Handholds reduce the drop height by lowering the container relative to the floor during handling. 8.) Labels such as fragile and handle with care have some effect but can be considered minor. 4.4.3.2 Drop Height Determination.
The drop height is determined from a number of factors. The size, weight and Level of Protection (4.3) are used to determine the appropriate drop height for analysis and testing purposes. See the table below revised from ASTM D 4169, Performance Testing of Shipping Containers and Systems, for an example of how to determine drop heights. These are recommended drop heights, check with the specific DOD entity to determine specific drop heights. (See Table IV). TABLE IV Drop Height, in.
(mm) Assurance Level 13 Downloaded from https://www.everyspec.com Shipping Weight, lb (kg) I (Level A) II (Level B) 0 to 30 (0 to 13.6) 36 (914) 36 (914) over 30 to 75 (to 34) 30 (762) 24 (610) over 75 to 150 (to 68) 18 (457) 15 (381)