MIL-HDBK-304C 5.5.3 Vibration Transmissibility. Any linear cushioning system can be represented by the set of generalized transmissibility curves presented in Figure 5-8 and those referenced in Appendix C. The transmissibility of a cushioning system is expressed as a non-dimensional ratio of its response amplitude to the excitation amplitude. The ratio may be one of forces, displacements, velocities, or acceleration. As indicated in Figure 5-8, the shape of the curve is affected by the degree of damping in the system. The transmissibility curves are referenced in Appendix C.
For best results, it is recommended that the designer use actual instrumented testing of each package system design to determine the system transmissibility. Note: In packaging testing, transmissibility represents the input acceleration from the vibration table over the output acceleration from the item. 5.5.3.1 Transmissibility Formula. The vibration transmissibility for a linear cushioning system is indicated by the function Tr , which is defined as the ratio of the force or motion transmitted to the mass through an isolation system to the force or motion exerted or described by the foundation (vehicle bed). The equation representing transmissibility ( Tr ) is as follows: (5:6) Where:
ff = the forcing frequency of the foundation fn = the undamped natural frequency of the item-cushioning system B2 = the fraction of critical damping of the cushioning material (1,5) The relationship between Tr , B2 , and forcing frequency ff for a viscous-damped linear system such as depicted by Figure 5-6 is illustrated in Figure 5-9. As shown, the transmissibility of such a system increases from unity to a maximum as ff /fn approaches 1.0 (resonance). Theoretically, for B2 = 0 , Tr is an infinite value. However, since all systems possess some damping, Tr is 28 Downloaded from https://www.everyspec.com