N/A (no manufacturer mentioned) N/A — MIL-HDBK-304C Package Cushioning Design Handbook PDF Download

MIL-HDBK-304C Creep-time curves for various cushioning materials are not given herein because these data have, so far, been unavailable for the commonly used range of static stress. However, designers might be able to obtain creep-time data from the manufacturers or vendors of cushioning material. If creep-time data are available, the extra thickness required to offset creep can be calculated by the following formula: Ta = T + (Creep%) (T) (5:17) 100 Where: Ta is the thickness of material required to protect the item, including the extra allowance to offset creep T is the original thickness of material required to protect the item without allowance for creep.

Creep is the expected percentage loss of material over time If the calculation of Ta indicates an unavailable thickness, it is generally advisable to use the next greater thickness of material. A suggested method for determining the creep characteristics of cushioning materials is given in paragraph 9.1.8. 5.9 Tensile Strength and Flexibility. Minimum tensile strength and flexibility are customarily prescribed in cushioning material specifications in order to make sure that the materials will not fail during normal handling and application, especially during wrapping operations.

Suggested test procedures to evaluate minimum tensile strength and flexibility are given in paragraphs 9.1.10 and 9.1.14, respectively. 5.10 Dusting and Fragmentation. Despite large differences in their composition, all cushioning materials, if subjected to scuffing or miscellaneous rough handling, will release some fragments. These fragments might then become widely scattered. Inside a package, the liberation of such particles is particularly objectionable when such items as optical equipment are being shipped because the jostling associated with shipment causes the particles to work into remote spaces of the item.

In addition to possible damage to the item, considerable labor in cleaning might be required before the part is usable. Outside a package, the liberation of such particles may constitute a nuisance, both as litter and airborne particles. Dusting and fragmentation testing procedures are discussed in paragraph 9.1.11. 5.11 Corrosion Prevention Cushions may react to the container material causing corrosion. Corrosion is the deterioration of a material by chemical action, usually as the result of oxidation, galvanic, acid, or alkali action. Corrosion can cause pitting or etching or the formation of loose or granular particles.

The package designer must insure that the cushioning material will not react with the container or the item so as to cause corrosion. The contact corrosivity test is commonly used to determine if the cushioning material will cause corrosion. See paragraph 9.1.15. 37 Downloaded from https://www.everyspec.com