Downloaded from https://www.everyspec.com MIL-HDBK-304C 6.0 PACKAGE DESIGN AND APPLICATION TECHNIQUES After the package designer has: defined the shipping, handling and storage environments; determined the item characteristics; researched product redesign (if necessary); and has researched the various cushioning materials, it is now time to design the cushioning system which in turn determines the size of the container needed. Shock and vibration calculations are required to ensure that the packaging system will adequately and efficiently protect the item. 6.1 Shock Design Procedure. Cushioning design for shock protection primarily involves peak acceleration-static stress curves.
However, cushioning design also requires various supplemental considerations, including application techniques and buckling. In all cases, it is very important to perform actual drop tests of packaging configurations, as the theoretical calculations can only estimate actual performance. 6.1.1 Make initial estimate. To obtain an initial estimate of the type of cushioning and its dimensions needed to protect a particular item, the designer will refer to the peak acceleration- static stress curves referenced in Appendix B . The designer first determines the static stress of the item against the cushioning.
Then the designer refers to sets of peak acceleration-static stress curves for the anticipated impact conditions and determines directly the kind and thickness of material required to protect the item. To illustrate the method, the following example is given: PROBLEM: A 20-pound (9 kg), 15-inch (375-mm) cubical rigid item having a fragility rating of 80 G must be protected from a 30-inch (0.75 m) flat drop. Determine what size of pads of the polyethylene represented by Figure 6-1 is optimum for protection of each face of the item by (a) complete encapsulation, (b) side pads, and (c) corner pads (See paragraph 6.3). SOLUTION:
The static stress (force/area) of any side of the item is 20 lbs force /(15x15) inІ = 0.09 psi (621 Pa). In Figure 6-1, point "A" represents the coordinated 0.09 psi and 80 g. The curves for the various thicknesses of material indicate that a 3-inch thickness (75 mm) of material is required to protect the item. Thus, if the item is to be encapsulated in cushioning material, a 3- inch thickness (75 mm) of material on all faces is required. 39