U.S. Department of Defense MIL-HDBK-704-3 — NOT MEASUREMENT

Downloaded from https://www.everyspec.com MIL-HDBK-704-3 TABLE TAC-I. Summary of Three Phase, 400 Hz, 115 volt utilization equipment MIL-STD-704 compliance tests. Note 1: Starting operation conditions are usually not applicable to AC utilization equipment. No test is required for TAC501 unless specified by the equipment performance specification. 3 UUT: Compliance to MIL-STD-704 Edition(s): Test Dates:

Test Method Description Performance (Pass/Fail) Comments Normal, Aircraft Electrical Operation TAC101 Three Phase Load and Current Harmonic Measurements TAC102 Steady State Limits for Voltage (Including Unbalance) and Frequency TAC103 Voltage Phase Difference TAC104 Voltage Modulation TAC105 Frequency Modulation TAC106 Voltage Distortion Spectrum TAC107 Total Voltage Distortion TAC108 DC Voltage Component TAC109 Normal Voltage Transients TAC110 Normal Frequency Transients Transfer, Aircraft Electrical Operation TAC201 Power Interrupt Abnormal, Aircraft Electrical Operation TAC301 Abnormal Limits for Voltage and Frequency TAC302 Abnormal Voltage Transients (Overvoltage/Undervoltage) TAC303 Abnormal Frequency Transients (Overfrequency/Underfrequency) Emergency, Aircraft Electrical Operation TAC401 Emergency Limits for Voltage and Frequency Starting, Aircraft Electrical Operation TAC501 See Note #1 Power Failure, Aircraft Electrical Operation TAC601 Power Failure (Three Phase) TAC602 One Phase and Two Phase Power Failures TAC603 Phase Reversal