everyspec.com — everyspec.com — MIL-HDBK-310: Global Climatic Data for Developing Military Products (PDF Manual)

Downloaded from https://www.everyspec.com MIL-HDBK-310 40.1.16 High Atmospheric Pressure. It is presumed that designing for the highest recorded extreme does not present any design problems. Extremes of high atmospheric pressure are discussed in: (33) Court, A. (1969) Improbable pressure extreme: 1070 mb, Bull. Am. Meteorol. Soc. 50, 4:248-250. (34) Loewe, F. (1969) More on "Improbable pressure extreme: 1070 mb", Bull.Am. Meteorol. Soc. 50, 10:804- 806. 40.1.17 Low Atmospheric Pressure. Discussion in 5.1.17 is considered complete. 40.1.18 High Atmospheric Density. Discussion in 5.1.18 is considered complete. 40.1.19 Low Atmospheric Density.

Information provided for this climatic element was taken from: (35) Cormier, R.V. (1972) Extremes of Low Atmospheric Density Near the Ground for Elevations up to 15,000 ft for MIL-STD-210B, AFCRL-TR-72-0711, Air Force Surveys in Geophysics No. 251, AD755791. 40.1.20 Ozone Concentration. Ozone concentration extremes at the ground were estimated by extrapolating to zero elevation the information aloft referenced in 40.3.1.1 for ozone concentration (Ref. nos. 45, 46, and 47). 40.1.21 Sand and Dust. Extremes of sand/dust likely to be encountered by military equipment are not those of nature, but rather those caused by heavy traffic over dry dirt roads.

Such extremes are not true climatic extremes and as such do not belong in this standard. However, design for these elements is extremely important, and since extremes for design purposes will probably not appear elsewhere, it was decided to present the most logical values of these elements in MIL- HDBK-310. The information presented in 5.1.21 through 5.1.21.2 was taken from: (36) Blackford, P.A., and McPhilimy, H.S. (1972) Sand and Dust Considerations in the Design of Military Equipment, ETL-TR-72-7, U.S. Army Engineer Topographic Laboratories, Ft. Belvoir, VA. Subsequent amendments to this report by McPhilimy were not published. 40.1.22 Freeze-Thaw Cycles.

Information on freeze-thaw conditions in 5.1.22 through 5.1.22.2 were taken from the following two reports: (37) Wexler, R.L. (1982) A General Climatological Guide to Daily Freezing Conditions: Frost Days, Ice Days, and Freeze-Thaw Days, ETL-0287, U.S. Army Engineer Topographic Laboratories, Fort Belvoir, VA. (38) Wexler, R.L. (1984) Diurnal Freeze-Thaw Frequencies in Selected Regions of the High Latitudes, ETL-0364, U.S. Army Engineer Topographic Laboratories, Fort Belvoir, VA. 40.2 Supplement to Regional Surface Environments. The methodology used to determine the four regional types into which the land areas of the world are partitioned was taken from reference (14) in 40.1.6.

The climatic data provided for the coastal/ocean regional type, for those elements (or combinations) that have less severe extremes than the worldwide surface environment, or pertain strictly to the marine environment, were taken from: (39) Crutcher, H.L., Meserve, J., and Baker, 5. (1970) Working Paper for the Revision of MIL-STD-210A to MIL- STD-210B, U.S. Navy, Naval Weather Service Environmental Detachment, National Weather Records Center, Federal Building, Asheville, North Carolina. 106