everyspec.com — everyspec.com — MIL-HDBK-310: Global Climatic Data for Developing Military Products (PDF Manual)

Downloaded from https://www.everyspec.com MIL-HDBK-310 5. DETAILED REQUIREMENTS AND GUIDELINES The climatic information presented in this section is divided into three major subdivisions. Section 5.1 provides data for materiel intended for worldwide use (see 1.3). Section 5.2 provides data that represent specified regions. Since regions representing a specific type of weather are not generally contiguous, the climatic data are said to apply to "regional types. The world is divided into five regional types, of which four cover the land areas. The fifth regional type covers the coastal/ocean environment (see 4.2).

Section 5.3 provides data on the worldwide air environment up to an altitude of 80 km for airborne and air-projected equipment. 5.1 Worldwide Surface Environment. The data in this section are based on surface weather observations over land areas. Information for each climatic element is generally divided into three subsections. The first provides the most extreme value ever recorded. The second subsection presents values that occur for specified frequencies-of- occurrence during the most severe month (see 4.1(a)). The third subsection presents long-term climatic extremes that would be equalled or exceeded at least once during 10, 30 or 60 years of exposure (see 4.1(b)).

In general, equipment should be designed to operate during all but a certain small percentage of the time (see 4.3.3(b)). Once an acceptable frequency of occurrence of a climatic element has been determined, the corresponding climatic value can be ascertained from the data in the second subsection for each element. It is recommended that a 1- percent frequency be initially considered for all climatic elements except cold temperature, for which a 20-percent frequency is recommended, and rainfall, for which a 0.5-percent frequency is recommended. Values corresponding to several frequencies of occurrence are provided for most climatic elements.

These and other data in Appendix A are for trade-off analyses (see 4.3.4). More extreme climatic values should be considered for equipment whose failure to operate is life-threatening, or for materiel that could be rendered useless or dangerous after a one-time exposure (see 4.3.3(c)). An option for such materiel would be protection from exposure to these extremes. 5.1.1 High Temperature. Temperatures discussed in this section were observed in standard meteorological instrument shelters. They represent temperatures of the free air in the shade about 1.5 m above the ground. These high temperatures will normally be encountered only during strong sunshine and fairly light winds.

The ground surface will attain temperatures 15 to 30 ° C higher than that of the free air, depending upon radiation, conduction, wind, and turbulence. Air layers very close to the surface will be only slightly cooler than the ground, but the decrease with height above the surface is exponential so that temperatures at 1 m will be only slightly warmer than that observed in an instrument shelter. The temperature attained by military equipment exposed to high temperatures will vary greatly with the physical properties of the equipment affecting heat transfer and capacity, and with the type of exposure.

(Probably the worst exposure is that of equipment placed on the ground in the direct sunshine.) The heat load from a realistic diurnal air temperature and solar radiation cycle (data that can be provided from meteorological records) make up only a part of the heat transferred to the equipment. The equipment temperature will also be dependent on solar radiation reflected to it from the ground, long wave radiation from the heated ground, long wave radiation to the cold sky, scattered solar radiation from the sky and nearby clouds, the vertical temperature distribution in the free air surrounding the equipment, and total ventilation from wind and turbulence. 6