everyspec.com — everyspec.com — MIL-HDBK-310: Global Climatic Data for Developing Military Products (PDF Manual)

Downloaded from https://www.everyspec.com MIL-HDBK-310 5.1.7.3 Long-term Extremes. A value of 100 percent with the temperatures given in 5.1.2.3. 5.1.8 Low Relative Humidity with High Temperature. Lowest relative humidities approach zero percent in hot deserts distant from bodies of water. 5.1.8.1 Lowest Recorded. A relative humidity of 2 percent at 43.3 ° C (110 ° F) was recorded in Death Valley, California. 5.1.8.2 Frequency of Occurrence. Since the percentile values of low relative humidity vary very little, the RH cycle in Table I (page 72) is recommended. 5.1.8.3 Long-term Extremes.

The relative-humidity cycle associated with the long-term high temperature extremes in Table II (page 73) is recommended. 5.1.9 Low Relative Humidity with low Temperature. Not available. 5.1.10 Wind Speed. Observations of wind speed are one of the least standardized of all meteorological elements. The exposure and height above the ground of wind-measuring equipment is far from uniform. Because windspeeds near the ground can vary significantly with height and exposure, specifying this variability is an important problem. Another problem, the interval over which wind speeds are averaged, varies from country to country.

The current standard averaging period in the United States, 1 min, is considered representative of the values herein referred to as the "average or steady wind." Gusts associated with steady wind speeds must also be considered. The gust factor is the ratio of the gust speed to the steady windspeed. Although many factors influence this ratio, one can develop approximations for the gust factor as a function of steady windspeed. Gust speeds reported in weather observations are normally considered to be about 2-sec averages, but for designing various sized equipments, other short-duration gusts are often applicable.

A previous study indicates that a gust must have a duration such that its size is about eight times the downwind dimension of a structure in order to produce a force on the structure commensurate with the gust speed. For example, a structure with a 3 m downwind dimension must have a 24 m long gust to establish full dynamic pressure on the structure. Smaller structures will be sensitive to shorter-duration gusts. The most probable gust extremes associated with the 1-min steady extremes presented in the following sections are scaled to arbitrarily chosen downwind equipment dimensions of 0.6, 1.5, 3, 8, 15, and 30 m.

Because the placement of most equipment will not take into consideration the direction of the extreme windspeeds, the shortest horizontal dimension of the equipment should be considered the downwind dimension. 12