Downloaded from https://www.everyspec.com MIL-HDBK-310 5.1.12.2 Frequency of Occurrence. The horizontal mass fluxes, one percent value, at heights ranging from 0.05 to 10 m, driven by wind speeds of 25 knots at the 3-m level (the 1-percent wind speed in central Canada during January) are: Data for 5- and 10-percent values are not available, and it is recommended that the above values be applied to any equipment that is susceptible to the effects of blowing snow. The typical particle-size distribution and associated temperature is provided in 5.1.12. 5.1.12.3 Long-term Extremes. Not applicable for this climatic element. 5.1.13 Snow Load.
Snow that falls on shelters, buildings, and equipment will impose a structural load on the supporting surface and must be considered in the design of the structure or equipment. The magnitude of the load depends not only on snowfall accumulations and densities, but also on the configuration of the receiving surface and whether or not snow is typically allowed to accumulate. Measurements of snow loads on structures and equipment are not normally available; therefore, the snow-load values must be estimated based on measured ground surface snow accumulations.
Such estimates are difficult to make and are subject to large errors; however, snow loads on equipment will usually be much less than on the ground because of structure slope, internal heating, and greater exposure to wind. Snow-load criteria for permanently installed equipment, which is designed and built for a specific location, must be determined by special studies based on the maximum snow load ever observed or expected in that location. Values for snow load are given for three classes of transportable equipment. These are: (a) Portable Equipment. Usually small items, such as tents, that may be moved daily.
This equipment generally will shed snow, but in instances where it does not, the resultant distortion will require mandatory daily clearing. The load for portable equipment is based on 24-hour snowfalls. (b) Temporary Equipment. Usually includes large items on which snow can collect, i.e., rigid shelters, portable hangers, etc. that can be cleared of snow between storms. The load for this type of equipment is based on snowfalls resulting from storms that last longer than 24 hours.
18 HEIGHT MASS FLUX (m) (ft) 2 (gm/m sec) 2 (lb/ft sec) 10 7.5 5.0 2.5 1.0 0.75 0.50 0.25 0.10 0.05 33 25 16 8.2 3.3 2.5 1.6 0.82 0.33 0.16 2.2 3.3 4.0 6.9 16 22 32 66 200 530 -3 0.45 x 10 0.68 0.82 1.4 3.3 4.5 6.6 14 41 109