everyspec.com — everyspec.com — MIL-HDBK-310: Global Climatic Data for Developing Military Products (PDF Manual)

Downloaded from https://www.everyspec.com MIL-HDBK-310 5.2.2Hot Regional Type. This regional type includes the hot subtropical deserts of the world where the 1-percent temperature during the worst month exceeds 43.3 ° C (110 ° F) as shown in Figure 1 (page 101). The worldwide surface extremes for the climatic elements discussed in 5.1.1, 5.1.3, 5.1.5, and 5.1.8 occur within this regional type. The hottest parts of this regional type are the hottest areas of the world as discussed in 5.1.1 through 5.1.1.3. Other parts of this regional type, while not as hot, are prone to occurrences of the highest absolute humidities in the world, as discussed in 5.1.3 through 5.1.3.2.

Therefore, two cycles are provided to describe these diverse climatic conditions. 5.2.2.1 Hot-Dry Diurnal cycle. This daily cycle of temperature and associated elements, provided in Table I (page 72), occurs in the hottest parts of the world as discussed in 5.1.1 through 5.1.1.3. 5.2.2.2 Hot-Humid Diurnal cycle. This daily cycle of temperature and associated elements, provided in Table IV (page 75), occurs in the area of the world that experiences the highest absolute humidities as discussed in 5.1.3 through 5.1.3.2. 5.2.3Cold Regional Type.

The cold regional type is characterized by temperatures that are lower than those of the basic cold daily weather cycle, but higher than those of the severe cold regional type. The cold regional type requires only one daily weather cycle to establish its range of conditions. Figure 1 (page 101) indicates the areas of the world where the cold daily weather cycle occurs. These areas include most of Canada, and large sections of Alaska, Greenland, northern Scandinavia, northeastern USSR, and Mongolia. Cold conditions also exist in parts of the Tibetan Plateau of Central Asia and at high elevations in both the Northern and Southern Hemispheres.

The worldwide surface extremes for the climatic elements discussed in 5.1.12, 5.1.13, and 5.1.14 occur within this regional type. 5.2.3.1 Cold Diurnal cycle. This daily cycle of temperature and associated elements is provided in Table XII (page 83). 5.2.4Severe Cold Regional Type. Except for Antarctica, which is excluded from consideration in this standard, the severe cold regional type records the world's lowest temperatures. Thus, the extreme temperatures of this type are identical with the worldwide extremes for low temperature as discussed in 5.1.2 through 5.1.2.3.

Also, the worldwide surface extremes for the climatic elements discussed in 5.1.4, 5.1.7, 5.1.12, 5.1.16, and 5.1.18 occur within this regional type. 5.2.4.1 Severe Cold Diurnal cycle. No cycle in tabular format is presented for the severe cold regional type, because temperature, solar radiation, and humidity remain nearly constant for the 24-hour period. Temperatures are provided in 5.1.2 through 5.1.2.3. 5.2.5Coastal/Ocean Regional Type. This regional type includes open seas and coastal ports north of 60 ° S (see 4.2 (c)). Climatic data are excluded for the periods during which locations are closed to navigation due to sea ice.

Information for each climatic element is generally divided into three subsections. The first of these is the most extreme value ever recorded. The second subsection presents values that occur for specified frequencies-of-occurrence during the most severe month (see 4.1 (a)). The third subsection presents long-term climatic extremes that would be equalled or exceeded at least once during 10 to 60 years of exposure (see 4.1 (b)). In general, equipment should be designed to operate during all but a small percentage of the time (see 4.3.3 (b)).

Once an acceptable frequency of occurrence of a meteorological element has been determined, the corresponding climatic value can be obtained from the second subparagraph for each element. It is recommended that a 1-percent frequency be initially considered for all elements except rainfall rate, for which a 0.5-percent frequency is recommended. More extreme climatic values should be considered for equipment whose failure to operate is life-threatening, or for materiel that could be rendered useless or dangerous after one-time exposure (see 4.3.3 (c)). Another option for such material would be protection from exposure to these extremes. 28