Downloaded from https://www.everyspec.com MIL-HDBK-310 5.2.5.13 Ice Accretion. The following information on this climatic element was based on design requirements in use in Iceland, the United Kingdom, and the USSR. 5.2.5.13.1 Highest Recorded. Ice 17 cm thick was measured on a Russian vessel. This corresponds to a load of 143 kg/m 2 for a typical ice density of 847 kg/m 3 . 5.2.5.13.2 Frequency of Occurrence. Not applicable since design to withstand a one-time occurrence is desirable. 5.2.5.13.3 Long-term Extremes. For exposed horizontal surfaces, a loading of 30 kg/m 2 (6 lbs/ft 2 ) corresponding to an ice thickness of 3.5 cm (1.4 in) for a typical density of 847 kg/m is recommended.
For exposed vertical surfaces, a loading of 15 kg/m 2 (3 lbs/ft 2 ) corresponding to a thickness of 1.8 cm (0.7 in) is recommended. 5.2.5.14 Hail Size. Not available. 5.2.5.15 High Atmospheric Pressure. Not available. 5.2.5.16 Low Atmospheric Pressure. Designing for the lowest recorded sea level pressure of 870 mb (see 5.1.17.1) should not present difficulty and is recommended for design. 5.2.5.17 High Atmospheric Density. See discussion in 5.1.18. 5.2.5.17.1 Highest Recorded. A density of 1.56 kg/m 3 (.097 lb/ft 3 ) with the temperature of -39 ° C in 5.2.5.2.1. 5.2.5.17.2 Frequency of Occurrence.
A density of 1.53 kg/m 3 (.096 lb/ft 3 ) based on the 1-percent temperature of - 34 ° C in 5.2.5.2.2. 5.2.5.17.3 Long-term Extremes. The highest recorded value is recommended. 5.2.5.18 Low Atmospheric Density. Extremes of low density in the maritime environment will occur where temperatures are highest and pressures lowest. Using the high temperature extreme of 51 ° C with an assumed pressure of 1000 mb results in a density of 1.075 kg/m 3 . Using the extreme of low pressure (870 mb) with an assumed temperature of 29 ° C results in a density of 1.004 kg/m 3 . Thus the lowest recorded density in the maritime environment is associated with the low pressure extreme.
However, since such low pressures are rare occurrences, the 1-percent low density value should be based on the 1-percent high temperature. 5.2.5.18.1 Lowest Recorded. As described above, a density of 1.004 kg/m 3 can be assumed for lowest recorded. 5.2.5.18.2 Frequency of Occurrence. The 1-percent high temperature extreme with which to calculate the 1- percent low density extreme is 48 ° C. Assuming a pressure of 1000 mb with this temperature results in a density of 1.085 kg/m 3 . 5.2.5.18.3 Long-term Extremes. Not available. 5.2.5.19 Ozone Concentration. The values discussed and presented in 5.1.20 through 5.1.20.3 are recommended. 32