everyspec.com — everyspec.com — MIL-HDBK-310: Global Climatic Data for Developing Military Products (PDF Manual)

Downloaded from https://www.everyspec.com MIL-HDBK-310 Climatic information for the worldwide air environment is presented in terms of envelopes of climatic values in 5.3.1, and profiles of temperature, density, and rainfall rate/water concentration in 5.3.2 (see 4.3.1(b)). The data presentations are discussed at the beginning of each section. 5.3.1Atmospheric Envelopes. Climatic data in this section are values of extremes at each altitude regardless of the location or month in which they occurred.

Therefore, the values provided for each altitude do not generally occur at the same time and place for layers greater than a few kilometers, and are not representative of the influence of the total atmosphere on a vertically rising or descending vehicle. These envelopes are most applicable for determining conditions at specific altitudes of concern for vehicles horizontally traversing the atmosphere, or for determining which altitude may present the most severe adverse effect for each climatic element.

For each climatic element, information is provided for the recorded extreme (up to 30 km), and for the frequency of occurrence during the most severe month in the worst part of the world (excluding areas south of 60 ° S) for that element. long-term climatic extremes are not provided since military equipment will not be permanently deployed or in a standby status in the free atmosphere. Values with a 1-, 5-, 10-, and 20-percent frequency of occurrence are presented. It is recommended that a 1-percent value be initially considered for all climatic elements with the exception of precipitation rate and water content for which 0.5-percent value is recommended.

For those items that may be rendered dangerous or inoperable during exposure to percentile values, the use of the recorded extremes may be more appropriate for design purposes (see 4.3.3(c)). Climatic data up through 30 km (98,425 ft) are generally given for both actual (geometric) and pressure altitude. Values above this altitude are provided for only geometric altitude. Actually the geometric altitudes to 30 km are geopotential heights, but for design purposes these may be considered geometric heights above sea level; for instance at 30 km, the difference between geopotential and geometric heights is 143 m, and less than that at lower altitudes.

Information at geometric altitudes is applicable in missile design whereas information at pressure altitudes is applicable in aircraft design since aircraft generally fly on given pressure surfaces. Pressure altitude is the geopotential height corresponding to a given pressure in the Standard Atmosphere. The heights given by most altimeters are based on the relationship between pressure and height in the Standard Atmosphere. Since atmospheric conditions are seldom standard, aircraft flying at a given pressure altitude may be at significantly different true altitudes above sea level; an aircraft flying at a constant pressure altitude may be ascending, descending, or flying level.

Extremes for zero altitude represent conditions at sea level for which the values in 5.1 generally apply. linear interpolation between adjacent levels is acceptable to obtain extremes for heights not specified. For pressure and density, logarithmic interpolation will be more accurate. Details on the data and analytical methods used to determine the information in this section are provided in Appendix A. 5.3.1.1 High Temperature. 5.3.1.1.1 Highest Recorded. Temperatures given at actual (geometric) and pressure altitudes follow. Densities associated with temperature extremes at actual altitudes are included. 34