Downloaded from https://www.everyspec.com MIL-HDBK-802 (SH) 2 July 1990 loops, regardless of whether two, three, or more loops abut along this boundary. The loop currents are represented by numbers or symbols placed near the centers of the loops with a curved arrow over the expression for the current to indicate the direction of the loop current. Now use the scheme of figure 81 (C) to resolve the circuit shown on figure 80 into current loops. The result is shown on figure 82.
We have three sets of loops in vertical planes between lines 1-4 and 1’-4’, lines 6-8 and 6’-8’, and lines 9-10 and 9’-10’; two sets of loops in a horizontal plane between lines 1’ -4’ and 6’-8’ and lines 5’-8’ and 9’-1O’; and a single vertical loop 11-11’ -12’ -12. We must also have a loop represented by line 13-14 as we will see later. It remains to find the loop currents for the loops on figure 82. Start out with loop 1-1’ -2’-2. The only current from point 2 to 1 is the loop current, hence, the loop current must be equal to the current shown from point 2 to 1 on figure 80, namely, 2A - 2B + 4C. The loop currents for the other loops between lines 1-4 and 1’ -4’ are found in the same way.
These loop currents must give the correct values for the currents in the commutator risers between points 1 and 1’, 2 and 2’, 3 and 3’, and 4 and 4’. A little consideration of figures 81 and 81 shows that they do. The next step is to find the loop current for loop 1- Along line 1’ -2’ this loop abuts against loop 1-1’ -2’-2. Furthermore , there is zero current in line 1’ -2’ . To satisfy this condition, the loop current must be 2A - 2B + 4C for loop 1’-5’-6’ -2’. The loop currents for the remaining loops between lines 1’ -4’ and 5’-8’ are found similarly and are shown on figure 82. FIGURE 81. Resolution of circuit into current loops. We now move down to line 5’-8’.
We have three loops abutting along line 6’-11’ : two horizontal loops, 2’-6’-11’-7’ -3’ and 11’ -6’-5’-9’ -12’, and one vertical loop, 6-6’-11’ -11 must be (4-2c)(A+B)+4C to give the right current along line 6-11. We now know the current loops in two of the three loops abutting along line 6’-11’ . The current in the third loop must be so chosen as to make the current along line 6’-11’ equal to zero. This condition gives (6-2c)A+(2-2c)B for the loop current in loop 11-6’-5’-9’ -12. A similar procedure is used to find the loop currents in the other loops between lines 5’-8’ and 9’-10’ . The next step is to find the loop current in loop 9-9’ -12’ -12’.
T WO loops meet along line 9’-12’; namely, 9-9’- 12’-12 and 5’-9’-12’-11’-6’ With loop current directions as shown on the figure, it is immediately apparent that the loop currents in these two abutting loops must be equal and opposite to make the current along 9’-12’ equal to zero. In a similar way, we find the loop currents in the other vertical loops between lines 9-10 and 9’-10’. There is one more loop needed to complete the loop system. This is represented on figure 82 by the line 13-14. A straight line does not look much like a loop; but it must be remembered that in the actual machine this line will be bent around in the form of a circle and have its ends connected. Line 13-14 141