NAVSEA MIL-HDBK-802(SH) — MIL-HDBK-802(SH) Design of Electrical Equipment with Small Stray Magnetic Fields Manual PDF

Downloaded from https://www.everyspec.com MIL-HDBK–8O2 (SH) 2 July 1990 the brush collector ring. Current can be forced to flow in such a path by proper design of the brush rigging. Now look at a longitudinal horizontal section through half of the armature and brush collector rings. The heavy line on figure 95 shows the current path from the armature winding to the positive brush collector ring for our initial assumption of point contact between a brush set and a commutator bar. For our new assumption of line contact, the current paths will be as shown on figure 96.

We obtain this current distribution from that shown on figure 95 by adding a number of small current loops of which loop 1-2-3-4 on figure 96 is a representative. FIGURE 95. Longitudinal section through half of machine for point contact between brushes and commutator bars. These loops will be in a plane that passes through the axis of the machine. We shall assume that the current taken by the brush set for an infinitesimal element of length dx is idx/(Ll+~), where i is the total current taken by the brush set and ~ are the distances shown, Look at the current that is taken from an element of length at a distance x to the left of the central brush collector ring.

It forms a loop 1-2-3-4 having a length x and width T that will have a magnetic moment directed down into the plane of the paper. its magnetic moment is as follows: L1 and 158