NAVSEA MIL-HDBK-802(SH) — MIL-HDBK-802(SH) Design of Electrical Equipment with Small Stray Magnetic Fields Manual PDF

Downloaded from https://www.everyspec.com MIL-HDBK-802(SH) 2 July 1990 (a) If this magnetic field can be contained within an enclosure or a volume and does not impact magnetic silencing, it is not a stray field. (b) If the magnetic field is desirable, it is not a stray field. 3.2.1 Measuring stray magnetic field, The stray magnetic field at a point can be calculated in simple cases (when no iron or other magnetic material is present). and can be measured in all cases. It can be measured as follows: (a) Measure the magnetic field at the point in question when the current in the circuit or equipment is different from zero.

(b) Measure the magnetic field at the same point when the current in the circuit or equipment is zero, all other conditions being the same. (c) Subtract the second measured value from the first. 3.3 Design for smallest stray magnetic field, 3.3 1 General. In order to design electric circuits and equipment with small stray magnetic fields, it is necessary to be able to estimate how much stray magnetic field will be produced by different circuits and equipment. Only when this can be done is it possible to make a rational choice of the arrangement that will give the smallest stray magnetic field, 3.3.2 The effect of a ferromagnetic material on a magnetic field.

3.3.2.1 The magnetic field of a ferromagnetic material. Ferromagnetic materials have a substantially higher relative magnetic permeability than nonferromagnetic materials. The induced magnetic field of a ferromagnetic material is proportional to the relative magnetic permeability of the material. Therefore, the higher the relative magnetic permeability of the material, the greater the induced magnetic field of this material will be. 3.3.2.2 The effects of ferromagnetic materials on the magnetic field of a conductor .

The magnetic field created by the current in a conductor is shown on figure 1, with the current going into the page, If there is some ferrous material near to this conductor, the magnetic field of the conductor will be distorted. A magnetization will be induced into the ferromagnetic material, which is proportional to the current in the conductor and to the relative magnetic permeability of the ferromagnetic material. The magnetic field caused by the ferromagnetic material in the presence of a current carrying conductor is shown on figure 2. As figure 2 clearly indicates, the two fields tend to cancel each other above the conductor and tend to reinforce each other below the conductor.

Bear in mind that the more magnetic field lines that are shown, the stronger the magnetic field will be. FIGURE 1. Magnetic field of a conductor 2