NAVSEA MIL-HDBK-802(SH) — MIL-HDBK-802(SH) Design of Electrical Equipment with Small Stray Magnetic Fields Manual PDF

Downloaded from https://www.everyspec.com MIL-HDBK-802(SH) 2 July 1990 FIGURE 38 (A). Four radial dipoles on the xz plane - case 1 - Continued, 4.3.3.18.1 Example of the use of radial dipole configuration equations. In the example that follows, we shall use equation 4-102 to illustrate a method of calculating the magnetic field due to a radial array of dipoles. Basically, we will follow the procedures listed in 4.3.3.1.1. The only change from 4.3.3.1.1 would occur in the case of a dipole not lying along one of the coordinate axes. This situation will be considered in step (c). (a) Identify the number of coils for which we want to calculate the magnetic field.

(b) Determine the distance between each dipole and the origin of the coordinate axes. In our example, each dipole is at a distance (c) Use equation 4-1 (M = ANI) to calculate M for each dipole. To determine the direction of M, we shall follow the rules listed below. of 4.3.3.1.1(c). (2) If some dipoles do not lie along a coordinate axis then the dipole is positive if it points toward the origin, and negative if it points away. (1) If all dipoles lie along a coordinate axis, we follow the rules (d) Next, we make a sketch of the dipole configuration and compare it to those of 4.3.3.18 through 4.3.3.26. As in 4.3.3.1, if a partial match occurs, use superposition to construct a complete match.

If no match occurs, use appendix A to derive the necessary equations . For our example, we use the equations of 4.3.3.18, specifically equation 4-102 since we are interested in the z component of magnetic field. Equation 4-102 is as follows: 59