NAVFACENGCOM MIL-HDBK-1001/l — NAVFACENGCOM MIL-HDBK-1001/l: Руководство по архитектурным требованиям и принципам проектирования

Downloaded from https://www.everyspec.com MIL-HDBK-1001/l 5 .5.1.2 Implementation. In implementing the system safety approach, the customer activity is responsible for preparing or providing funds to the EFD for obtaining a Preliminary Hazard Analysis (PHA) . The information from the Pm shall be used during design to ensure that hazards are eliminated or controlled through engineering or a combination of measures. The designer shall consult with the EFD Occupational Safety and Health Manager to determine specific safety and health requirements’ for each design and to coordinate contacts with EFD system safety personnel. 5.5.2 Fire Protection.

MIL-HDBK- 1008 contains NAVFACENGCOM requirements for fire protection such as building separations, construction, exit requirements, and sprinkler design. It is mandatory that required fire and safety protection features be identified and incorporated at initial project discussion stages to eliminate ‘costly additions later. 5.5.3 Asbestos Protection. NAVFACENGCOM policy on asbestos is stated in OPNAVINST 5100.23, Naw Occupational Safetv and Health (NAVOSH) Proeram Manua 1. This document requires that building materials containing asbestos be substituted with building materials containing no asbestos where suitable substitutes exist.

Life cycle cost, durability, maintenance requirements , and fire- and heat- resistant properties are among the characteristics to consider in determining the suitability of substitute materials For some renovation projects, asbestos removal and disposal may not be identified in the project’s scope of work. If materials are suspected to contain asbestos, the designer should contact the NAVFACENGCOM EFD project manager for procedures to identify, test, and remove the materials containing asbestos Refer also to NFGS-02080, Removal and Disposal of Asbestos Materials 5.5.4 Exulosion Protection.

Facilities where explosions may occur, such as ammunition depots and fusing-defusing buildings , must have explosion safety features. Blow-out windows , doors, panels. and roof elements , as well as explosion-proof electrical fixtures are mandatory. MIL-HDBK-1028 series contain additional criteria. 5.5 Radiation Protection. Facilities with nuclear and radiological features shall be designed according to Code of Federal Regulations 10 CFR 20, Standards for Protection A~ainst Radiation, and to applicable requirements of the National Council on Radiation.

Protection and Measurements (NCRPM) and the National Institute of Standards and Technology (NIST) Assistance in determining the extent of applicability of these criteria will be provided by the Director, Naval Sea Systems Command Detachment, Radiological Affairs Support Office (RASO) , Yorktown, VA 23691. 5.5.6 Termite Protection. DOD policy requires that buildings be protected from termite damage in geological locations where termite infestation is present. General Navy policy is to provide protection by soil treatment. Individual EFD points of contact should be contacted for local policy on . termite protection.

For example, in buildings without wood components or with little wood (such as wood doors on metal frames or wood blocking at the roof level) , one EFD policy is to omit soil treatment. Another EFD policy in this 16