Print Workflow After the printer stops, the operator can remove the fabric from the core that finished printing, then handle any issues such as folds in the fabric edge by hand. 119 WARNING For the following reasons, perform settings so that printing ends with 3 m or more of fabric left. • If the ending edge of the fabric is not affixed to the core, the fabric can slip off the core, meaning it is not held by the brake or tension device and cannot properly adhere to the belt. If printing continues in that state, the fabric can become caught on the head and damage the head.
• If the ending edge of the fabric is affixed to the core, the belt is pulled by the piece at the end of the fabric, putting excessive strain on the belt motor. This could cause belt motor malfunctions. CAUTION We recommend always using the Pause printing option. Using this option lets you set the length (meters) to be printed. When printing stops, the machine pauses and waits for the next command. pauses and waits for the next command. A test print should be at least 1 m, to check for banding due to misalignment of the print heads. Print 1 Click the [Start] button. 2 If the "Enable belt cleaning" message is displayed, click [YES]. 3 The print cycle starts.
The printed fabric is fed to the belt on the take-up side of the machine front. If there are any print quality problems, refer to "Print Quality" on page 147. Checking the Cleaning Unit Confirm that water is provided to the cleaning unit and check the water level in the tank. Printing Ends After it finishes printing the set length, the printer stops in PAUSE mode. A test print should be at least 1 m, to check for banding due to misalignment of the print heads. If there are any print quality problems, refer to "Print Quality" on page 147.