EPSON — Prepare the Fabric

Workflow before Beginning Work Prepare the Fabric Before setting the fabric, be sure to confirm the following status. • Fabric edge: Confirm that there are no folds or protrusions and that the fabric is not lifted up or frayed. If the fabric is frayed, perform overcasting. • Seams: Confirm that there are no protrusions and that the fabric is not frayed. If fiber containing moisture from the ink lifts up, it may come into contact with the head passing over the fabric. To avoid this, make the fabric edge firmly adhere to the belt. 69 WARNING If the fabric touches the head, the head may be damaged.

The fabric must be fed and adhere to the belt without any folds, protrusions, seams, or lifting in the fabric edge whatsoever. CAUTION If the fabric thickness and print head height are set incorrectly, the print head may collide with the fabric, resulting in a malfunction. Set the fabric thickness and the foreign material detection sensor when loading the fabric for the first time or changing the fabric type or thickness. For more information about fabric thickness, refer to "Set the Fabric Thickness and Head Height" on page 111. For more information about the foreign material detection sensor, refer to "Set the Foreign Material Detection Sensor" on page 108.